Epson EMP-1825 - User Manual

Questions and Answers

A
Alexandra LopezSep 15, 2025
Why is email not sent even if an abnormality occurs in the Epson EMP-1825?
- B
  Brooke JohnsonSep 15, 2025
  If e-mail is not sent even if an abnormality occurs in the projector, it could be due to several reasons: * The wireless LAN unit is not connected; check that the wireless LAN unit is securely connected. * The network connect setting is incorrect; check the projector's network settings. * "Standby Mode" is not set to "Network On"; set "Network On" in "Standby Mode" from the configuration menu. * A fatal abnormality occurred and the projector came to a sudden stop; contact your local dealer or the nearest address. * Power is not being supplied to the projector; check that your electrical outlet or power source is functioning correctly. * The network cable is not connected correctly; reconnect it if it is not connected or not connected properly.
M
Matthew MooreSep 17, 2025
What should I do if my Epson Projector has one or more connected projectors that do not support resolutions greater than SXGA?
- F
  fjacksonSep 18, 2025
  If one or more connected projectors do not support resolutions greater than SXGA, and there is an ELP-735 projector in the connection destination, change the computer's screen resolution to SXGA (1280 1024) or less.
M
Marvin RichNov 19, 2025
Why is my Epson EMP-1825 Projector not found when EMP NS Connection is started?
- H
  Heather FordNov 19, 2025
  The Epson Projector might not be found when EMP NS Connection is started due to several reasons: * The wireless LAN unit might not be securely connected; ensure it is properly connected. * The projector's configuration menu might be open; close it and return to the EasyMP standby screen. * The computer's LAN card or built-in LAN function might not be available; validate LAN in the device manager. * SSID might not match the access point; set a different SSID. * DHCP function for wired LAN might be turned ON; turn OFF the DHCP setting for Wired LAN in the configuration menu. * The network adapter used was not selected correctly; select the correct network adapter from Set options - Switch LAN. * Wireless LAN setting might not be enabled in power save mode; enable wireless LAN...
A
alexalopezNov 26, 2025
Why are the image and sound for movies with EMP NS Connection not displayed correctly on my Epson EMP-1825 Projector?
- K
  Kristin FreemanNov 26, 2025
  If the image and sound for movies with EMP NS Connection are not displayed, the image is slow, or the movie/audio stops, it could be due to: * Movies played with Media Player or a screen saver preview tried to operate; the movie playback screen in Media Player may not be displayed, and the screen saver preview may not be displayed normally, depending on the computer. * WEP encryption being active or multiple projectors connected; the display speed decreases. * DHCP not being enabled; when DHCP is set to "On", if a DHCP server that can be connected to is not found, it takes time to enter EasyMP standby status. * EMP NS Connection started during movie playback or resolution and color number changed; start EMP NS Connection before starting playback. * Wireless LAN 802.11g/b being u...