38
List of Functions
"Info" Menu
Lets you check the status of the image signals being projected and the status of the projector. (Display only)
Sub-menu Function
Lamp Hours Shows the cumulative lamp operating time.
If it reaches the lamp warning time, the characters are displayed in yellow. The cumulative operating time from 0 to 10 hours will be displayed as
"0H". From "10H" onwards, the display will be in units of 1 hour.
Source Displays the input source which is currently being projected.
Input Signal Displays the input signal settings.
(Does not appear when the input source is composite video or S-video.)
Resolution Displays the input resolution.
(Does not appear when the input source is composite video or S-video.)
Video Signal Shows the video signal format.
(Not displayed for computer, RGB video, or component video images.)
Refresh
Rateg
Displays the refresh rate.
(Does not appear when the input source is composite video or S-video.)
Sync.g Info Information from this menu may be required when you ask for service from your dealer or from the nearest address provided in the
"International Warranty Conditions" section of the Safety Instructions/World Wide Warranty Terms booklet.
(Does not appear when the input source is composite video or S-video.)
Computer/RGB Video/Component videog Composite videog/ S-Videog
To Next Page
Loading...
Need help?
General
