16
Adjusting the Projection Position (Image Shift)
When you cannot setup this projector directly in front of the screen, the
projection position can be finely tuned without moving this projector.
PROCEDURE
A
Using the button on the projector, perform zoom
adjustment or keystone correction. sp.i
The Image Shift adjustment screen is displayed after you finish
making adjustments.
B
Adjust projection position.
C
Press the [Esc] button to close the adjustment
screen.
The screen closes automatically if no operations are performed
for about 10 seconds.
•The projection position cannot be adjusted when zoom
is set to maximum "wide".
•Even if you turn the power supply off, the "Image
Shift" settings you make are kept. When either the
projector position or the angle of the projector is
changed, you can readjust or perform the following
operations.
•You can also make adjustments from the configuration
menu. sp.35
Using the Remote Control Using the Control Panel
Press and hold down the
[Wide] and [Tele] buttons
for more than one second.
Control Panel
To Next Page
Loading...
Need help?
General
