Epson EMP-S3 User Manual

45
Problems Solving
Lamp replacement notification Replace the lamp with a new one. sp.58
If you continue to use the lamp after it has passed the replacement period, the possibility that the
lamp may break will increase. Replace the lamp with a new one as soon as possible. The Power
indicator status will vary depending on the projector status at the time.
•If the projector is not operating properly even though the indicators are all showing normal, refer to "When the Indicators Provide No
Help" on the following page.
•If an indicator is showing a status which does not appear in the previous tables, contact your dealer or the nearest address provided in
the "International Warranty Conditions" section of the Safety Instructions/World-Wide Warranty Terms booklet.
: lit : flashing : off
Status Cause Remedy or Status
Orange
Power

Epson EMP-S3 Specifications

General

Brightness	1600 ANSI lumens
Resolution	800 x 600 (SVGA)
Contrast Ratio	400:1
Display Technology	3LCD
Screen Size	30 - 300 inches
Lamp Type	170W UHE
Lamp Life	3000 hours (standard), 4000 hours (eco mode)
Projection Lens	Manual focus
Input Ports	VGA, Composite, S-Video
Output Ports	VGA
Operating Temperature	5°C to 35°C