Epson Endeavor - Configuring GEM for the New Drivers

Configuring GEM for the New Drivers
Follow these steps to configure GEM to use the new VGA
drivers:
1.
2.
3.
Insert the GEM/3 System Master Disk in drive A.
Log onto drive A.
Type the following and press to start the GEM/3
Setup program:
GEMSETUP
4. Follow the instructions on the screen until you see
Change existing configuration.
5.
Select OTHER ( DRI VE R PACK ). You’ll be prompted to
insert a screen driver into drive A.
6.
Insert the GEM DRIVRPK diskette you created in drive A.
You’ll see the two drivers listed below:
Cirrus Logic VGA 16 Color 800 x 600
Cirrus Logic V GA 16 Color 1024 x 768
7. From this list, select the driver you want to use.
8.
Follow the instructions on the screen to complete the
installation.
24 VGA Utilities