Epson Endeavor - Configuring the Drivers

4.
When the INSTALL program asks you to identify your
Windows directory, press to accept the default or
delete the default and type the path for your Windows
directory.
5.
Select OK or press The program copies the Windows
drivers and the SetRES utility to the program directory and
creates a SetRES utility icon in your Windows program
manager.
6.
When you see the message telling you that the drivers and
utility were successfully added, select OK or press
Nate
You’ll need to use the Utility 2 diskette again when you
configure Windows 3.0 to use the drivers.
Configuring the Drivers
Once you have used the INSTALL program to copy the drivers
to your Windows program directory, follow these steps to
configure the drivers:
1.
End your Windows session and exit to MSDOS.
2.
Log onto your Windows program directory.
3.
Type SETUP and press
4.
At the System Information screen, select Display and press
5.
From the Display menu, select Other (Requires disk
provided by a hardware manufacturer) and press
6.
The program prompts you to insert your display driver
diskette in drive A. Insert the Utility 2 diskette in drive A.
32 VGA Utilities