Epson Endeavor - Copying Framework II Drivers; Installing the Drivers

Copying Framework II Drivers
Follow these steps to copy the Framework drivers to the root
directory of a diskette:
1. Use the INSTALL program on the Utility 1 diskette as
described on page 6 to copy the drivers to the diskette.
When the program prompts you to supply a drive and
directory, type a directory on your hard disk where you can
easily locate them to copy them to a diskette; for example:
C : \TEMP
2. Select the Framework Il drivers and respond to the prompts
as they appear on the screen. The program displays the
names of the drivers as it copies them to your hard disk.
3. Insert a formatted diskette in drive A.
4. Use the MS-DOS COPY command to copy the drivers from
your hard disk to the root directory of the diskette in drive
A; for example:
COPY C:\TEMP\AVGAFW2*.SC A:\
Installing the Drivers
Follow these steps to install the Framework II drivers:
1. Log onto your Framework II program directory.
2. Type SETUP and press to run the Framework II Setup
program.
3. At the Welcome menu, select All other uses of the
setup program and press
4. Select Current directory and press
18 VGA Utilities