Leaving the Setup Menu
If you want to save the settings you entered, highlight
** EXIT AND SAVE ** and press Enter at a Setup
summary screen. The Setup program stores the new settings and
resets the computer using the new configuration. If you have set
a password, you need to enter it at the key prompt. (See “Using
a Power-on Password” in Chapter 3 for instructions.) The
Operation Menu appears. Press 0 and Enter to exit the
Operation Menu.
If the computer displays an error message while it is starting up,
run the Setup program again and check the setting the error
message indicates. If the computer still displays an error message
after you check your Setup program settings, see Appendix C or
ask your dealer for assistance.
After you save the settings you entered, remove the Reference
diskette from your diskette drive and turn off your system. Then
follow the instructions in your MS-DOS Installation Guide to
install MS-DOS.
Running the Setup Program
2-31
To Next Page