Epson Equity 386/25 - Modifying the Device List

For example, you may see this menu:
Suppose the first option is highlighted. If you want to select that
option, just press Enter (because it is already highlighted). If
you want to select option 2, you can either press 1 or 2; this
causes the cursor block to move to that option. Then press
Enter to select it.
Therefore, when the instructions in this appendix tell you to
select an option, you can either use to highlight
the option or you can type the number of the option. Then
press Enter. (You must press Enter to start the operation.)
Modifying the Device List
If an installed device is missing from the Device List, you must
add it to the list and test it carefully. At the following prompt,
select N.
DEVICE LIST is correct ? (Y/N)
D-4
Performing System Diagnostics