See “Setting the Power-on Password” in Chapter 2 for
instructions on how to set a power-on password and enable
network server mode.
Using a Password in Network Server Mode
After you enable network server mode and boot the system from
the hard disk, you see the following prompt:
C:\>
You do not see the key prompt ( ) even though the
computer is waiting for you to enter the correct password.
Follow these steps to enter your password:
1.
Type your password and press
Enter. You do
not see
anything you type and the prompt does not change.
2.
Press Enter again. You see the C : \ > prompt appear again
beneath the first prompt, as shown below.
C:\>
C:\>
Now, you can access the system.
If the C : \ > prompt does not appear, you entered an
incorrect password. Type the correct password and press
Enter twice to access the system.
Using the Equity 386/25
3-13
To Next Page
Loading...