Epson FX Series

Summary
You enter Graphics
Mode with the CHR$(27)“K”
CHR$(n
1
) CHR$(n
2
) command. You determine the number of graphics
columns by filling the two reservation slots, n
1
and n
2
. You fire your
pin patterns by adding up the pin labels, which consist of powers of
two.
Here is the command we introduced in this chapter:
CHR$(27)“K”CHR$(n
1
)CHR$(n
2
);
Enters Single-Density Graphics Mode and spe-
cifies width setting. Width = n,+256*n,
where n
1
is 0 - 255 and n
2
is 0 - 7 on the FX-80
and 0 - 12 on the FX-100
Note: Single-Density graphics dots are printed 60 per inch horizon-
tally and 72 per inch vertically.
142