Figure 12-1. STRATA layout
In most cases the program reads a number greater than or equal to
zero and sends it to the printer (line 620). Control then returns to line
610, which reads the next number.
If N is negative, the program bypasses the LPRINT in line 620 and
goes on to line 630. Negative numbers in the DATA lines represent
repeat factors as they did in the last chapter, but the repeat routine is
slightly different. This program repeats numbers in pairs:
630
READ P,R: FOR J=l TO -N:
LPRINT CHR$(P)CHR$(R);: NEXT J
640
GOT0
610
For example, when the negative 16 in line 800 is read into N, control
passes to line 630. Line 630 reads the next two numbers (16 and 64)
into P and R and prints them 16 times. Control then returns to line
610, which reads the next number.
161
To Next Page
Loading...
Need help?
General
