Epson LQ 300 - Removing the HP Sensor

Disassembly and Assembly
LG?-300 Service Manual
3.2.4.5
Removing the HP Sensor
1. Remove theprinter mechanism (see Section 3.2.4).
2. Release the 2 clips attaching the HP sensor and remove it. The clips
can be accessed though 2
holes in the base frame. To release the clips, push each with a pair of tweezers.
Base
Figure 3-14. Removing the HP Sensor
3.2.4.6 Removing the Release
Lever Position Sensor
1. Remove the PFmotor assembly (see Section 3.2.4.1).
2. Release the 2 clips that attach the release lever position sensor to the frame of the
PF motor
assembly.
3. Remove the release lever position sensor from the frame of the PFmotor assembly.
Frame of the
Release Lever
PF Motor
Position Sensor
/
.
Clip
Figure 3-15. Removing the Release Lever Position Sensor
3-14
Rev.A