LQ-300 Service Manual
Adjustments
11.
12.
13.
14.
15.
After printing is complete, the following message appears on the display:
K
From the 5 rows of draft patterns, find the row in which the vertical lines in the H are best
aligned, then enter the value assigned to that row. The following figure is an example of the
Bi-D
printout.
After you enter the value for draft, the following message appears on the display:
m
From the 5 rows of LQ patterns, find
the
row in which the vertical lines in the H are best
aligned, then enter the value assigned to that row.
The printer lets you check your print pattern selection for confirmation following steps 9 and
10 by printing one row of the pattern you selected.
After the printer prints check patterns for confirmation, the following message appears on the
display:
ET
If
Bi-D
is correct, press “Y” and the Enter key, and
d
BI-D
M
incorrect, press N and
Enter. –
If your printed pattern is aligned vertically, press Y and Enter to complete the
Bi-D
adjustment. Otherwise, press N to return to step 11 to specify another adjustment
value.8.
Rev.A
4-5
To Next Page
Loading...
