Getting Started 15
Turning Off the Power
Before you turn off the viewer, make sure the memory card
access light is off. Then slide the power switch as shown
below, and hold it down for a few seconds until the activity
light flashes and the viewer turns off.
Saving Power
When you are not using the viewer, it goes into one of the
power-saving modes listed below. You can adjust the timing
for all of the power-saving modes; see “Power Save” on
page 60 for more information.
❍ The LCD screen turns dark after one minute of
inactivity. Press any button to turn it on.
❍ The LCD screen turns off after five minutes of
inactivity. Press any button to turn it on.
❍ The viewer turns off automatically after 10 minutes of
inactivity. Slide down the power switch to turn it back
on.
When the AC adapter is connected, the viewer plays a
screen saver instead of turning off.
To customize the screen saver, see “Selecting a Screen
Saver” on page 55.
Memory card
access light
Activity light
To Next Page
Loading...
Need help?
General
