Epson Perfection V500 Photo - Page 42

EPSON Perfection V500 Photo Revision A
DISASSEMBLY / ASSEMBLY Disassembly Procedure 42
5. Remove the torsion spring and the C.B. M3 x 3 screw that secure the Tensioner,
and remove the Pulley.
6. Remove the Motor Timing Belt and the CR Timing Belt from the CR Motor Unit
in that order.
Figure 4-27. Removing the Motor Timing Belt and the CR Timing Belt
A D J U S T M E N T
R E Q U I R E D
When installing the Tensioner, make sure to perform the Tensioner
Adjustment.
See Section 5.1.2.1 on page 53.
Torsion Spring
Tensioner
Motor Timing Belt
CR Timing Belt
C.B. 3 x 3
(6±1kgf.cm)
Pulley