57
6. Check the pattern to see if there are any gaps in the lines.
7. If there are no gaps, press OK to go back to the Maintenance menu.
If there are gaps, press Cancel to clean the print head again. You may need to
clean it two or three times before the nozzles are clean.
If you don’t see any improvement after cleaning three times, refer to Solving
Problems.
You can also turn PictureMate Pal off and wait overnight to allow any dried ink to
soften. Then try cleaning the print head again.
Aligning the Print Head Directly From PictureMate Pal
If you have moved PictureMate Pal and the print quality is not as good as it used to
be—if your prints look fuzzy or have light or dark lines running through them—you
may need to align the print head.
1. Load paper in PictureMate Pal so you can print the head alignment pattern. See
Loading Paper for details.
2. Press Menu.
3. Press or to highlight Maintenance and press OK.
4. Press or to select Head Alignment and press OK.
OK
Needs
cleaning
To Next Page
Loading...
