Epson PictureMate Pal - Printing From a Digital Camera

40
3. Press to increase the contrast of the screen or to reduce the contrast. Then
press OK.
4. Press Cancel to exit.
Returning to Default Settings
You can return your settings to the PictureMate Pal original default settings.
1. Press Menu.
2. Press or to highlight Reset Defaults and press OK.
You see a confirmation message.
3. Press OK to return to the original settings, or press Cancel to exit without
changing the settings.
Printing From a Digital Camera
You can connect a digital camera that supports PictBridge or USB DIRECT-PRINT
printing to PictureMate Pal and use the camera to control printing. (Check your
camera manual to see if it supports PictBridge or USB DIRECT-PRINT. A cable may
not be included with your camera.)
1. Make sure PictureMate Pal is on but not printing.
2. Make sure there are no memory cards in PictureMate Pal’s slots.
Note: If a memory card is inserted, the printer will read photos from the card, not
from a camera.
3. Turn on your camera.