Epson PictureMate Pal - Page 66

66
Close the cartridge door. The cartridge door is not closed completely on the back of
PictureMate Pal. Make sure the door clicks shut.
No cartridge installed.
Insert cartridge now.
The photo cartridge was removed or not installed correctly.
Install a new photo cartridge. See R
eplacing the Print Pack.
Cartridge not
recognized. Replace
Print Pack.
Install a genuine PictureMate 200 Series photo cartridge.
See R
eplacing the Print Pack.
No photos on memory
card.
No compatible photos are on the inserted memory card.
Insert a card with photos or one with compatible file types.
See P
hoto Image File Requirements.
Memory card not
recognized.
Use a compatible memory card. Format the card with your
camera, not a computer. See Compatible Memory Cards
and the supported file types in P
hoto Image File
Requirements.
Error in data. Printouts
may be affected.
Data in your photo files may be corrupted and may affect
your printouts.
Bluetooth adapter error. Disconnect the adapter, then reconnect it to PictureMate
Pal. See Printing Wirelessly From a Bluetooth Device
.
The image is too large. The image you are trying to print from a Bluetooth device is
too large. Print the photo from a memory card or your
computer instead.
The image is too
complex.
The image you are trying to print from a Bluetooth device is
too complex. Print the photo from a memory card or your
computer instead.
External device not
recognized.
An unsupported device is connected to the port on the
back of PictureMate Pal. Disconnect the device.
Printer error. Turn off PictureMate Pal, wait a few seconds, then turn it
on again. If the error does not clear, contact Epson as
described in Where To Get Help
.
Service required. Parts inside PictureMate Pal are near or at the end of their
service life. Contact Epson as described in Where To Get
Help.
Message What to Do