35
Removing the Used Photo Cartridge
Make sure you have a new PictureMate photo
cartridge before you begin. Once you start replacing a
cartridge, you must complete all the steps in one
session.
Caution: Before you replace the cartridge, read the “Photo
Cartridge Safety Instructions” on page 61.
1 Make sure PictureMate is on, but not printing.
2 Close the paper support.
3 Lift up the handle.
4 Open the cartridge door on the back of
PictureMate.
5 Move the photo cartridge lever to the Release
position by sliding it in the direction shown. This
releases the cartridge.
Caution: Do not try to pull out the cartridge without
releasing the lever.
To Next Page
Loading...
