Product Information 107
❏ Do not use in a place where lots of dirt and dust are present.
❏ Leaving discs stacked may result in discs sticking to each other.
❏ Let the discs dry naturally after printing. Touching the surface with your hand or
splashing the surface with water right after printing may result in blurriness and
stickiness.
❏ Printing is possible only on the printing surface. When printing by hand, use a soft,
tipped writing instrument like a felt pen, and do not use a ballpoint pen. Also, do not
erase once printed.
❏ The recording surface side has a concentric ring projection called the stack ring.
Depending on the disc, projection of the stack ring is small and use of such a disc may
cause the disc to stick before or after printing. It is recommended to check the disc
before use.
❏ The specified discs have a moisture-adhesive ink receptor layer on the label surface. If
stored stacked, especially under high humidity and high temperature conditions, disc
may adhere to each other. If an automatic duplication machine is used, please check
the disc before using.
Notes when storing discs
❏ Do not store in direct sunlight, near heating equipment, or high humidity and
temperature.
❏ Do not place where large temperature variance takes place, as condensation may
occur.
❏ Do not place an object on top of the disc.
❏ When storing, keep the disc in its disc case, and avoid letting film or cards touch the
printing surface. These may scratch the printing surface.
❏ Do not store discs in soft cases or bags which may touch the printing surface directly.
This may cause discs to stick; may cause color shading or discoloration.
❏ Avoid storing with part of the printing surface covered, as this may cause smearing or
discoloration.
❏ Avoid storing in high temperatures and high humidity, which may result in blurriness
and stickiness of the printing surface.
To Next Page
Loading...
Need help?
General
