Epson PP-100II - Page 31

31
Chapter 3 Setting
3
PP-100II / PP-100
EPSON Total Disc Setup Properties window is displayed. In the window, the following settings can be made.
Setting Item Explanation
Name You can change the name of PP-100II / PP-100. The name is used to be
specified in the JDF file using Publisher key.
Up to 64 characters can be used for the name.
You cannot register multiple PP-100II / PP-100 with the same name.
Stacker
Settings
Publish Mode Select the publishing mode from the following three options; “Standard
Mode”, “External Output Mode”, and “Batch Mode”.
When the read back mode is selected in PP-100II, a job cannot be
published from TD Bridge.
See the PP-100II / PP-100 User’s Guide for more information on the
publishing mode.
Stacker 1,2 When “Standard Mode” is selected:
Select disc type for Stacker 1 that is used for blank discs. Stacker 2 is used
for ejected (published) discs.
When “External Output Mode” is selected:
Select disc type for both Stacker 1 and 2 that are used for blank discs.
When “Batch Mode” is selected:
Select disc type for both Stacker 1 and 2 that are used for blank discs. An
error occurs if the disc type specified for Stacker 1 and 2 is different from
that specified in the JDF file.
Stacker 3 When “Standard Mode” is selected:
“Use” or “Do not use”
When “External Output Mode” is selected:
“Output Stacker” or “Do not use” can be selected:
When “Batch Mode” is selected:
“Output Stacker”