44
Setting Item List
The table below lists the available setting items in a JDF file. You may not need some of the settings.
Referring to each explanation, include the settings only required for your system.
Key name: Case sensitive. A key name including lowercase characters is ignored as an invalid command. Spaces
before and/or after a key name also make the key name invalid.
Setting: Characters written from immediately after "=" to a linefeed code or EOF are regarded as the setting.
End of instruction: The instructions written on the file are processed from the top and continued until a linefeed or EOF is
found.
Key
name
Explanation How to specify the setting
Maximum
characters
Available
characters
(strings)
Necessary/
Arbitrary
Except PP-
100AP, Key
available
Yes/No
PP-100AP
Key
available
Yes/No
JOB_ID Specify a job ID for
identification.
Specify a job ID that has not been used for
existing jobs. (this ID is used in a STF file as
hereinafter described, and for canceling the
job using a JCF file.)
When no job ID is specified, TD Bridge will
automatically create the ID.
40 characters One byte
alphanumeric, "-",
"_"
Arbitrary ●●
PUBLISHER Specify a name of
disc publishing
machine to be used
for the job.
Use the name registered by EPSON Total Disc
Setup.
When not specified, the publishing machine
specified in the Environment Setting of TD
Bridge will be used.
If the Environment Setting also has not
specified the machine, the machine
registered by EPSON Total Disc Setup will be
used as long as only one machine has been
registered.
(When multiple machines have been
registered, an error will occur)
64 characters Machine names
registered by
EPSON Total Disc
Setup.
Arbitrary ● ●
COPIES Specify the number
of discs to be
published.
[When the output device is other than PP-
7050BD]
Selectable from 1 to 1,000.
When not specified, only one disc will be
published.
[When the output device is PP-7050BD and
the mode is not set to Error Rate
Measurement Mode]
Selectable from 1 to 1,000.
When not specified, only one disc will be
published.
[When the output device is PP-7050BD and
the mode is set to Error Rate
Measurement Mode]
Selectable from 1 to 50.
When not specified, only one disc will be
published.
Four
characters
One bite
numbers
Arbitrary ●●
To Next Page
Loading...
