Epson PP-100II - Setting EPSON Total Disc Setup

To Next Page

To Previous Page

Setting EPSON Total Disc Setup

EPSON Total Disc Setup allows you to configure major setting for publishing discs, such as PP-100II / PP-100 / PP-100AP / PP-

50BD / PP-7050BD operation mode selection, source/output stackers selection.

This section explains only about the required settings to be used by the cooperative application.

Click [Start]-[All Programs]-[EPSON Total Disc Maker]-[EPSON Total Disc Setup] to start EPSON Total Disc Setup.

The [User Account Control] screen is displayed (Excluding Windows XP / Windows Server 2003).

Then, click [Continue].

Select the PP-100II / PP-100 / PP-100AP / PP-50BD / PP-7050BD to be used, and click [Properties].

 For PP-100N, settings other than the name cannot be changed.

 To change the settings of PP-100N, use EPSON Total Disc Net Administrator.

(See "Setting EPSON Total Disc Net Administrator" on page 3-34.)

Click

Select

Other manuals for Epson PP-100II