Epson RC700 User Manual

Maintenance 4. Backup and Restore
RC700 / RC700-A Rev.23 131
Restore the system configuration saved using Backup Controller only for the same
system.
When different system information is restored, the following warning message appears.
Click the <No> button (do not restore data) except for special situations such as
controller replacement.
When restoring the backup which includes the data of the robot configured to the Drive
Unit, be sure to restore the data while the Drive Unit is connected and turned on.
When restoring the backup including unsupported robot information to the target
controller, an error occurs.

NOTE

NOTE

NOTE

Epson RC700 Specifications

General

Maximum Axes	16
Communication Interfaces	Ethernet, EtherNet/IP, PROFINET, PROFIBUS, CC-Link, RS-232C, USB
Safety Standards	ISO 10218-1, ISO/TS 15066, IEC 61508, IEC 61511, ANSI/RIA R15.06
Operating System	VxWorks
Power Supply	24 VDC