Epson RC700 - Page 233

Maintenance 9. Troubleshooting
RC700 / RC700-A Rev.23 221
No.
Message
Remedy
Note 1
Note 2
3257
Condition expression does not
evaluate to Boolean value.
Condition expression in If, ElseIf, Do,
and Loop statement must return a
Boolean value. Correct the
condition expression to return a
Boolean value.
3258
RS232C port number was not
specified.
RS-232C port number is not specified
in ChkCom function. Refer to
SPEL+ Language Reference
“ChkCom Function” and specify a
proper port number.
3259
Network communication port
number was not specified.
Network communication port number
is not specified in ChkNet function.
Refer to SPEL+ Language Reference
“ChkNet Function” and specify a
proper port number.
3260 Language ID was not specified.
Language ID is not specified in
ErrMsg$ function. Refer to SPEL+
Language Reference
“ErrMsg$ Function” and specify a
proper language ID.
3261 Expected '.'. Add '.'.
3262
Vision Sequence Name was not
specified.
Vision sequence name is not
specified in Vision Guide commands
such as VSet, VGet,
and VRun. Add
a sequence name.
3263
Vision Sequence Name or
Calibration Name was not
specified.
Vision sequence name or calibration
name is not specified in VSet and
VGet statements. Add a sequence
name or calibration name.
3264
Vision Property Name or Result
Name was not specified.
Vision property name or result name
is not specified in VSet and VGet
statements. Add a property name or
result name.
3265
Vision Property Name, Result
Name or Object Name was not
specified.
Either of Vision property name, result
name, or object name is not specified
in VSet and VGet statements. Add
either of a property name, result
name, or object name.
3266
Vision Calibration Property Name
was not specified.
Vision calibration property name is
not specified in VSet and VGet
statements. Add a property name.
3267 Task type was not specified.
Task type is not specified in Xqt
statement. Refer to SPEL+
Language Reference “Xqt Statement”
and specify a proper task type.
3268 Form name was not specified.
Form name is not specified in GSet,
GGet, GShow, GShowDialog, and
GClose statements. Specify a form
name.
3269
Property Name or Control Name
was not specified.
Property name or control name is not
specified in GSet and GGet
statements. Specify a property
name or control name.
3270 Property Name was not specified.
Property name is not specified in
GSet and GGet statements. Specify
a property name.