Epson RC700 - Page 235

Maintenance 9. Troubleshooting
RC700 / RC700-A Rev.23 223
No.
Message
Remedy
Note 1
Note 2
3281 TextAlign was not specified.
TextAlign property setting value is not
specified in GSet statement.
This error occurs when the control
type cannot be identified because the
control is specified by a string
variable. Refer to GUI Builder 7.0
manual “TextAlign Property” and
specify a proper setting value.
3282 TextAlign was not specified.
TextAlign property setting value is not
specified in GSet statement.
This error occurs when the control is
a text box. Refer to GUI Builder 7.0
manual “TextAlign Property” and
specify a proper setting value.
3283 TextAlign was not specified.
TextAlign property setting value is not
specified in GSet statement.
This error occurs when the control is
other than a text box. Refer to GUI
Builder 7.0 manual “TextAlign
Property” and specify a proper setting
value.
3284 WindowState was not specified.
WindowState property setting value is
not specified in GSet statement.
Refer to GUI Builder 7.0 manual
“WindowState Property” and specify
a proper setting value.
3285 J1FLAG was not specified.
Specify 0 or 1, or an expression for
J1Flag value.
3286 J2FLAG was not specified.
Specify 0 or 1, or an expression for
J2Flag value.
3287
Robot ID was not specified.
Specify a robot number.
3288 Robot ID/All was not specified.
Robot number or All is not specified in
InsideBox and InsidePlane function.
Specify a robot number which
performs intrusion detection, or All.
3289 Area ID was not specified.
Area number is not specified in
InsideBox and InsidePlane function.
Specify an approach check area
number which returns status by an
integer from 1 to 15.
3290 File number was not specified.
File number is not specified in the
command related to file
management. Specify a file number
by an integer from 30 to 63 or an
expression.
3292 Database type was not specified.
Database type is not specified in
OpenDB statement. Refer to
SPEL+ Language Reference
“OpenDB Statement” and specify a
proper database type.
3293 Disk type was not specified.
Type of the disk that is subject to file
manipulation is not specified in
ChDisk statement. Refer to SPEL+
Language Reference “ChDisk
Statement” and specify a proper disk
type.