R4CE91P
BasicOperationGuide
Rev. C
PRTFLM.fm A4 size
7/20/04
L
Proof Sign-off:
S.Shimozawa CRE Kawakami
H.Kimura
editor name
20 Printing from Film
Printing from Film
Loading and Setting Film on the
Document Table
c
Caution:
Hold the film at its edges, or else use gloves.
Touching the film surface with bare hands can
leave fingerprints or other traces on the film.
Note:
Wipe the inside of the document cover and the document
table before scanning transparencies.
1. Make sure the document cover’s cable is
connected to the TPU interface connector and
open the document cover.
2. Remove the reflective document mat gently
along the document cover.
3. Load the transparency into the film holder and
position it on the document table. Follow the
instructions below as appropriate to your film.
35 mm film strips
1 Remove the film cover.
2 Set the film into the film holder with the base side
down. The base side of the film is the side where
the film maker's name and film ID numbers can
be read correctly.
3 Attach the film cover.
4 Place the film holder on the document table with
the side where the film is placed facing toward
you.
Top
Bottom
To Next Page
Loading...
