Epson Stylus Pro 3800 - Page 112

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 112
10. Remove the four screws that secure the BASE, ENCLOSURE to the main unit.
See Figure 4-27.
 Four C.B.S. 3 x 6 screws (6 ± 1 kgf.cm)
11. Pull out the BASE, ENCLOSURE from the back of the printer. See Figure 4-28.
12. Disconnect all the connector cables and the FFCs on the BOARD ASSY., MAIN,
and remove the BASE, ENCLOSURE. (Refer to “4.3.4.1 BOARD ASSY., MAIN”
(p113))
Figure 4-27. Removing the screws from the BASE, ENCLOSURE
Figure 4-28. Removing the BASE, ENCLOSURE
C A U T I O N
Note that the Main Board and the Power Supply Board are stored
in the BASE, ENCLOSURE, and they are connected to the main
unit with the cables. When removing the BASE, ENCLOSURE, be
careful not to separate it too much from the main unit to avoid
damaging the cables.
C A U T I O N
Do not disconnect/insert the FFCs from/into the connectors at an
angle. Doing so may damage, short, or break the terminals in the
connector resulting in a breakdown of the elements on the board.
C.B.S. 3x6
BASE, ENCLOSURE
BASE, ENCLOSURE
BOARD ASSY., MAIN