Epson Stylus Pro 3800 - Adjustment Program Basic Operations

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
ADJUSTMENT Overview 215
5.1.7 Adjustment Program Basic Operations
This section describes the basic operations of the Adjustment Program.
 System Requirements
 OS: Windows 2000, XP
 Interface: USB
 The printer driver must have been installed.
 Startup
When you start the Adjustment program for this printer, the NVRAM Backup
Utility will automatically start up. Unless carrying out parameter writing, execute
parameter reading before carrying out the adjustments. For operation of the
NVRAM Backup Utility, see "5.3.6 Parameter Backup" (Page 231).
1. Double-click on “adjwiz2.exe”, to start the NVRAM Backup Utility.
2. See "5.3.6 Parameter Backup" (Page 231) to execute parameter backup, and
complete the NVRAM Backup Utility.
3. The startup screen of the Adjustment Program appears. Select whether to
carry out the adjustments in Sequential Mode or Individual Mode.
4. Click [Start].
Figure 5-1. Adjustment Program Startup Screen
C A U T I O N
Since the adjustment program differs in Epson Stylus Pro 3800/
3800C/3850 and Epson Stylus Pro 3880/3885/3890, be careful not to
use the wrong one.