Epson Stylus Pro 3800 - Print Head

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 161
4.3.9.5 PRINT HEAD
1. Remove the HOUSING, UPPER. (p107)
2. Remove the COVER, CR. (p152)
3. Perform step 13. to step 16. in “4.3.9.3 INK, SYSTEM, ASSY.” (p153) to remove
the SELECTOR, INK, ASSY. from the CARRIAGE, ASSY.
4. Remove the screw that secures the MOUNTING PLATE, SELECT, INK and
remove it.
See Figure 4-89.
 One C.B.P. 2.5 x 8 screw (3 ± 1 kgf.cm)
Figure 4-89. Removing the MOUNTING PLATE, SElECT, INK
C A U T I O N
Since the PRINT HEAD of Epson Stylus Pro 3800/3800C/3850 and
Epson Stylus Pro 3880/3885/3890 has no compatibility, be careful
not to install the wrong one.
Insert the rib of the PRINT HEAD into the cutout of the
MOUNTING PLATE, SELECT, INK to secure the MOUNTING
PLATE, SELECT, INK.
C.B.P. 2.5x8
positioning point
MOUNTING PLATE,SELECT,INK