Epson Stylus Pro 3800 - Washing Head and Discharge Ink

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
ADJUSTMENT Standard Adjustment 251
5.3.14 Washing Head And Discharge Ink
 Purpose
Carries out head washing and discharging of ink.
 Procedure
1. Install PC Card Driver
1-1. Unzip the LZF826DIO_553F.exe in the [LZF826DIO] folder. Execute
the setup.exe in the [APIPAC/DIO/Disk1] folder to install the driver.
1-2. If a new hardware detection wizard is displayed, select the unzipped
folder of [INF/Win2000/Dio/PCCard].
2. Check DrvNo and GrpNo
2-1. Start Menu -> CONTEC API-PAC(W32) -> Start up API-TOOL
Configuration.
2-2. Remember the DrvNo and GrpNo in the board list of Configuration Tool.
2-3. Exit the Configuration Tool. At this time if the message to save in
registry is displayed, click [Yes].
3. Set DrvNo, GrpNo
3-1. In the screen of Head Washing and Ink Discharging in Adjustment
Program, key in the DrvNo and GrpNo as remembered in Step 2.
4. Head Washing & Ink Discharge
4-1. Click [Run] to Head Washing & Ink Discharge.
4-2. Click [Finish].
Figure 5-60. [Washing Head And Discharge Ink] Screen
C A U T I O N
This adjustment is provided only for refurbishing the Epson Stylus
Pro 3800/3880.