Epson Stylus Pro 3800 - T&B&S Adjustment

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
ADJUSTMENT Standard Adjustment 256
5.3.19 T&B&S Adjustment
 Purpose
Adjusts the position to start printing on the paper.
 Paper Used
 Size: A4/Letter
 Type: Enhanced Matte Paper (US)/
Archival Matte Paper (Europe, Asia)
 Standard
Margin 5mm
 Procedure
1. Turn the printer ON.
2. Start up the Adjustment Program and select [T&B&S Adjustment].
3. Click [Print] to print the adjustment pattern.
4. Referring to Figure 5-69, select the numerical value for the position where the
printed line is exactly 5mm away from the paper edge (for each left, right, top,
and bottom sides).
5. Enter the numerical values found in Step 4 into the corresponding edit boxes.
6. Click [Write] and then click [Print] to print the adjustment pattern again.
7. After confirming that all values are within the specified range, click [Finish].
If they are not, perform Step 4 to Step 6 again.
Figure 5-68. [T&B&S Adjustment] Screen
C A U T I O N
Be sure to place the adjustment pattern print on a flat surface when
performing the measurement.