Epson Stylus Pro 3800 - Cleaning the Printer

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 141
6. Remove the E-ring and the washer from the left side of the SHAFT, PAPER
GUIDE, BOARD PAPER.
7. Pull the SHAFT, PAPER GUIDE, BOARD PAPER to the right to push out the
parallel pin from the SPUR GEAR, 14.4, and pull out the parallel pin from the
SHAFT, PAPER GUIDE, BOARD PAPER.
8. Remove the SPUR GEAR, 14.4 from the SHAFT, PAPER GUIDE, BOARD
PAPER.
9. Remove the E-ring and the washer from the SHAFT, PAPER GUIDE, BOARD
PAPER.
10. Pull the SHAFT, PAPER GUIDE, BOARD PAPER to the right.
Figure 4-63. Removing the SHAFT, PAPER GUIDE, BOARD PAPER
 Insert the SPUR GEAR, 14.4 into the SHAFT, PAPER GUIDE,
BOARD PAPER as shown in the Figure 4-63, and insert the
parallel pin into the hole.
 Insert the SHAFT, PAPER GUIDE, BOARD PAPER into the
connection groove of the CAM, PAPER GUIDE, BOARD
PAPER on the left end of the main unit.
CAM, PAPER GUIDE,
BOARD PAPER
Connection Groove
SHAFT, PAPER
GUIDE, BOARD
PAPER
GUIDE, PAPER
GUIDE, BOARD
PAPER, LEFT
washer
Step 6
E-ring
Step 6
E-ring
Step 9
washer
Step 9
PARALLEL PIN
Step 7
SPUR GEAR, 14.4
Step 8