Epson Stylus Pro 3800 - Page 165

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 165
4.3.9.6 POROUS PAD, INK WASTE BOX, RIGHT/
POROUS PAD, INK WASTE BOX, LEFT
1. Remove the STACKER, ASSY. (p134)
2. Remove the screw that secures the INK WASTE BOX.
See Figure 4-94.
 One C.B.P. 3 x 8 screw (6 ± 1 kgf.cm)
Figure 4-94. Removing the screw from the INK WASTE BOX
C H E C K
P O I N T
When removing/installing the screw that secures the INK WASTE
BOX, insert a screwdriver (with a 140 mm or longer shaft is
recommended) through the hole on the FRAME ASSY., SUB,
RIGHT as shown in Figure 4-94.
Insert a screwdriver through this hole.
C.B.P. 3x6