Epson Stylus Pro 3800 - Page 185

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 185
4.3.10.2 TIMING BELT, PF
1. Remove the HOUSING, UPPER. (p107)
2.
Remove the SCALE, PF, 180. (p184)
3. Remove the retaining ring that secure the SPUR GEAR, 31.5.
See Figure 4-127.
4. Remove the two screws that secure the HOUSING, LOWER.
See Figure 4-128.
 Two C.B.P. 3 x 8 screws (6 ± 1 kgf.cm)
Figure 4-127. Removing the SUPUR GEAR, 31.5 (1)
Figure 4-128. Removing the screws from the HOUSING, LOWER
SPUR GEAR, 31.5 retaining ring
C.B.P. 3x8
C.B.P. 3x8
HOUSING, LOWER