Epson Stylus Pro 3800 - Page 199

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 2) 199
8. Disconnect the relay connector of the MOTOR ASSY., ASF, and release the
cables from the two cable hooks. See Figure 4-41.
9. Remove the four screws that secure the ASF, ASSY. See Figure 4-151.
 Two SHAFT, MOUNT, PLATEs: (9 ± 1 kgf.cm)
 Two C.B.S. (P4). 3 x 8 screws: (9 ± 1 kgf.cm)
10. Lift up the ASF, ASSY., to disengage the two tabs from the main frame and
remove the ASF, ASSY. See Figure 4-151.
Figure 4-151. Removing the ASF, ASSY.
A D J U S T M E N T
R E Q U I R E D
Whenever the ASF, ASSY., is replaced, the corresponding
adjustments must be carried out. See Chapter 5 "ADJUSTMENT"
(p208).
<Adjustment Item>
1. LD Roller Position Adjustment
2. Reset When ASF Unit Change
SHAFT, MOUNT, PLATE
tab
SHAFT, MOUNT, PLATE
tab
main frame
ASF, ASSY.
Rear side
C.B.S. (P4). 3x8 C.B.S. (P4). 3x8