Epson Stylus Pro 3800 - Page 205

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 2) 205
4.4.1.5 SHAFT, RELEASE, ASSY.
1. Remove the HOUSING, UPPER. (p107)
2. Remove the ASF, ASSY. (p197)
3. Remove the MOTOR, RELEASE, ASSY. (p187)
4. Remove the four screws that secure the SHAFT, RELEASE, ASSY. See Figure
4-159.
 Four C.B.S. 3 x 6 screws (9 ± 1 kgf.cm)
5. Lift up the SHAFT, RELEASE, ASSY. while pushing down the three tabs on the
SHAFT, RELEASE ASSY. See Figure 4-160.
6. Slide the SHAFT, RELEASE, ASSY. leftward to release the SHAFT, RELEASE,
PAPER GUIDE, UPPER from the main frame, and then remove the SHAFT,
RELEASE, ASSY. See Figure 4-160.
Figure 4-159. Removing the screws from the SHAFT, RELEASE, ASSY.
Figure 4-160. Removing the SHAFT, RELEASE, ASSY.
SHAFT, RELEASE, ASSY.
C.B.S. 3x6
Rear side of the printer
tabs
SHAFT, RELEASE, ASSY.
SHAFT, RELEASE, PAPER
GUIDE, UPPER
Rear side of
the printer