Epson Stylus Pro 3800 - Page 228

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
ADJUSTMENT Standard Adjustment 228
8. Loosen the three screws (A, B and C shown in Figure 5-24) that secure the
LEAF SPRING, LOCK, HEAD.
9. Slightly turn the head adjust lever upward and downward to correct the slant
of the print head.
z In case of NG Pattern 1: turn the head adjust lever downward.
z In case of NG Pattern 2: turn the head adjust lever upward.
10. Tighten the three screws loosened at Step 8 in the order of A
→ B → C
11. Click [Back] to go back to the previous screen and repeat Step 6 to Step 10
until the correct result is obtained.
Figure 5-23. Screws Securing the [LEAF SPRING, LOCK, HEAD]
Figure 5-24. Head Adjust Lever
A
C
B
Head Adjust Lever