Epson Stylus Pro 3800 - Page 27

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
PRODUCT DESCRIPTION Operation Panel 27
 PG settings list
The table below lists the platen gap amounts settable with the printer driver, control
panel, and media table.
 Firmware version indication
The table below explains the meaning of the “o0XXXX-xx.xx.IBC” (firmware
version).
Table 1-10. PG Setting List
Printer Driver
Paper Thickness
setting
Control Panel
Setting
Media Table or
Printer Driver
PG Setting
PG amount (mm)
No setting
0.0 to 0.8mm
NARROW
Minimum 0.9
Small 0.9
Middle 1.2
Large 1.5
STANDARD
Minimum 0.9
Small 1.2
Middle 1.5
Large 2.1
WIDE
Minimum 1.2
Small 1.5
Middle 2.1
Large 2.1
WIDER
Minimum 1.5
Small 2.1
Middle 2.1
Large 2.1
WIDEST
Minimum 2.1
Small 2.1
Middle 2.1
Large 2.1
0.9mm to 1.5mm -- -- 3.5
Table 1-11. Firmware Version Indication
Item Explanation
o0
A code assigned to each printer.
Special version is assigned to “0” (zero).
XXXX The version of the firmware installed on the printer.
xx.xx The version of the network firmware.
I A code assigned by product. The code of the printer is “8”.
B
When the business system functions are enabled, the printer settings are
indicated in hexadecimal (1 to F).
bit0: Graphic printing control function.
0: Disabled
1: Enabled
bit1: Credit function
0: Disabled
bit2: Credit counter
0: The credit function is disabled or the counter is “0” (zero).
1: The credit function is enabled and the counter is 1 or more.
bit3: Reserved
C
Shows the custom number when the custom operation has been set using
the special setting menu. “0” appears when such operation is not set.