Epson Stylus Pro 3850 - Removing the MOTOR ASSEMBLIES

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 120
4.3.5 Removing the MOTOR ASSEMBLIES.
4.3.5.1 MOTOR ASSY., APG
1. Remove the HOUSING, UPPER. (p107)
2. Pull out the BASE, ENCLOSURE. (p111)
3. Disconnect CN45 of the MOTOR ASSY., APG on the BOARD ASSY., MAIN.
See Figure 4-29.
4. Release the cables of the MOTOR ASSY., APG from the three cable hooks.
See Figure 4-38.
5. Peel off the acetate tapes on the COVER, ENCLOSURE, ASSY. to release the
cables of the MOTOR ASSY., APG. See Figure 4-39.
Figure 4-38. Releasing the MOTOR ASSY., APG cables (1)
Figure 4-39. Releasing the MOTOR ASSY., APG cables (2)
Route the cables of the MOTOR ASSY., APG, with other cables
and secure them with the acetate tapes as shown in Figure 4-39.
Cable hooks
Right rear of the printer
COVER, ENCLOSURE, ASSY.
Acetate tapes
Right rear of the printer