Stylus Pro 4000 Field Repair Guide 4/28/05
Main Board Replacement Printer Component, Software Item, LCD Display, Printer Button Page 54.
9. Fasten the new Board to the Housing with 9 Screws (see above) Do not fully tighten.
10. Install the Port Covers and 5 Screws
11. Full tighten the 9 Main Board Screws.
12. Connect the Cables to the Board. Ensure that the Cables are fully seated (straight).
5 Screws
Hold the Cable firmly in
place, while locking the
Release Mechanism.
Lift the Release Mechanisms on
these 4 Connectors
To Next Page
Loading...
