Stylus Pro 4000 Field Repair Guide 4/28/05
Pump and Cap Removal Printer Component, Software Item, LCD Display, Printer Button Page 95.
6. Remove 2 Screws fastening the Platen Gap Motor, and remove.
7. Remove 2 Screws fastening the Gear and Shaft Assembly, and remove.
8. Slide the Cap and Pump Assembly to the right, to separate the Assembly from the Gear.
2 Screws
Remove the Motor
2 Screws
Remove Gear
and Shaft
Assembly.
Separate the Assembly
from the Gear
Slide the Cap and Pump
Assembly this way.
To Next Page
Loading...
