Remove when the optional SpectroProofer is
installed.
E
Open the cutter cover.
Pull the cover towards you while holding down
the lock as shown in the figure to open the cover.
F
Remove the old cutter from the printer.
Loosen the screw holding the cutter in place
using a cross-head screwdriver and pull the
cutter straight out.
c
Caution:
Do not store the cutter within the reach of
children. The cutter's blade could cause an
injury. Pay careful attention when replacing
the cutter.
G
Install the new cutter.
Insert the cutter so that the pin on the printer
matches up with the hole on the cutter. Use a
cross-head screwdriver to tighten down the
screw to hold the cutter in place.
Note:
Screw up the cutter firmly, otherwise the cut
position may be slightly shifted or skewed.
Epson Stylus Pro 4900/4910 User's Guide
Maintenance
125
To Next Page
Loading...
