Making Settings for Mac OS X
A
When the Print screen is displayed, select the size
of the data created with the application in Paper
Size.
When using Mac OS X 10.4, or if items on the
Page Setup screen are not displayed on the Print
screen due to the application being used in Mac
OS X 10.7, 10.6, or 10.5, display the Page Setup
screen and make settings.
U “Basic Printing Methods(Mac OS X)” on
page 44
You can also perform borderless banner printing
by selecting the Paper Size as shown below.
Where XXXX is the actual paper size, such as A4.
XXXX (Roll Paper - Banner): Prints a 0 mm
margin at the top and bottom, and a 3 mm
margin on the left and right.
XXXX (Roll Paper - Borderless Banner): The
printer driver expands the print area by
approximately 3 mm to the left and right in
regards to the paper width so that there is no 3
mm margin on the left and right. Therefore, you
need to create data that is 3 mm wider than the
paper size on the left and right in advance. The
top and bottom margins are 0 mm.
Select Manage Custom Sizes from the Paper
Size list, and then set the paper size.
B
Make settings in Scale to enlarge the size of the
document you created in your application to the
size of the paper you want to print on.
If Scale is not displayed on the Print screen, open
the Page Setup screen, and then make the
settings.
You can now print as normal.
Epson Stylus Pro 4900/4910 User's Guide
Printing Varieties
88
To Next Page
Loading...
