Epson Stylus Pro 7000 - Page 149

EPSON Stylus Pro 7000 Revision B
Disassembly & Assembly Disassembly Flow 149
4.2.3.18 Removing the Flushing Box Assembly
1. Remove the Maintenance Assembly as described in “Removing the
Maintenance Assembly” on page 143.
2. Using tweezers, remove the Cleaner Head from the Pump Assembly.
NOTE: Make sure the Cleaner Head surface is free from any dirt, dust,
or grease. Also, when mounting it, use tweezers to keep the
wiping side of the Cleaner Head clean.
3. Remove the one (CUPS M3x6) screw securing the Flushing Box Assembly
and remove the Flushing Box Assembly.
Figure 4-75. Removing the Flushing Box Assembly
Screw
(M3x6)
Flushing Box
Assembly