Epson Stylus Pro 7000 - Service Call 00010001; Service Call 00010002; Service Call 00010003

EPSON Stylus Pro 7000 Revision B
Troubleshooting Errors That Require a Service Technician 94
SERVICE CALL 00010001

Problem
PF motor out of step - the length of the PF motor internal encoder’s
pulse is too long or too short compared to the regular pulse.

Solution
Make sure there is nothing blocking the grid rollers. If that does not
solve the problem, check the PF motor encoder connection. If there
still is a problem, try the following.

Check and adjust the PF Belt tension

Replace the PF motor

Replace the Main Board
SERVICE CALL 00010002

Problem
PF motor overcurrent - Feedback from the PF motor (IC35) driver’s 10-
pin output (sensor signal) indicates that the PF motor’s current is
irregular.

Solution

Replace the PF motor

Replace the Main Board
SERVICE CALL 00010003

Problem
PF in-position time-out - The in-position time is the amount of time
the printer waits to make sure the carriage is not moving when the
carriage comes to a stop. The rotary encoder is activate for the
predetermined “in-position time” and if the encoder sends a pulse,
this means the carriage is moving even though it is supposed to be at
a full stop, this generates an error.

Solution

Replace the PF motor

Replace the Main Board