Epson Stylus Pro 7000 - Vibration & Shock; Controller

EPSON Stylus Pro 7000 Revision B
Product Description Features 20
VIBRATION & SHOCK
See the following table.
Notes:
* Make sure the printhead is capped during transportation and storage. To cap
the printhead, turn the power on (with ink cartridges installed) and turn the
power off when the printheads are capped.
* To thaw frozen ink in the printer or cartridge, leave the printer out at a
temperature of 25°C (77°F) for approximately three hours.
1.1.9 Controller
CPU: Hitachi SH7043, 33Mhz
RAM: 8MB + 2MB (fixed)
Interfaces: IEEE1284
USB
Type B (one expansion port)
Table 1-12. Vibration and Shock
Condition
Vibration
Resistance
Shock
Resistance
Notes
Operating
0.15G
10~55Hz
1G
maximum 1ms
X/Y/Z directions
Storage
0.5G
10~55Hz
2G
maximum 2ms