Epson Stylus Pro 7000 - Service Call 00010006; Service Call 00010007; Service Call 00010008

EPSON Stylus Pro 7000 Revision B
Troubleshooting Errors That Require a Service Technician 96
SERVICE CALL 00010006

Problem
CR motor overcurrent - Feedback from the CR motor (IC33) driver’s
10-pin output (Sense signal) indicates that the CR motor’s current is
irregular.

Solution

Check the CR cover, slightly loosen screws if necessary

Check the cutter housing, slightly loosen screws if necessary

Make sure no foreign material or ink tubes (from pump assembly) are
blocking the carriage path (see “Removing the Maintenance
Assembly” on page 143 for reassembly points)

Replace the CR motor

Replace the Main Board
SERVICE CALL 00010007

Problem
CR in-position time-out - The in-position time is the amount of time
the printer waits to make sure the carriage is not moving when the
carriage comes to a stop. The linear encoder is activate for the
predetermined “in-position time” and if the encoder sends a pulse,
this means the carriage is moving even though it is supposed to be at
a full stop, this generates an error.

Solution

Replace the encoder sensor

Replace the CR motor

Replace the Main Board
SERVICE CALL 00010008

Problem
Servo interrupt watchdog time-out error due to motor-drive control
related error

Solution
Replace the Main Board