Epson Stylus Pro 7000 - Self-Diagnostic Mode; Firmware Update

EPSON Stylus Pro 7000 Revision B
Product Description Firmware Update 51
SELF-DIAGNOSTIC MODE
Power-on button: Paper Feed
↓
+ Cut/Eject + Cleaning
This mode is used primarily for replacing worn-out printer parts and
adjustment operations. For details, see Chapter 5, "Adjustment".
1.9 Firmware Update
The firmware contained on the Main Board is Flash ROM; therefore if you
need to update the firmware or replace the Main Board, see “Parameter
Backup” on page 159 and “Firmware Update” on page 162 for details.
CHECK
PO INT
The information contained in this section is not to be shared
publicly.